lundi 23 mai 2016

Day 5

 Today's job was to finish the arching, after the re-curve was done I had to blend it with the arch. Then it was just a mater of going over the whole plate with a really fine adjustment on the planes to get all the ridges/bumps off. Later on it was time for scraping in every directions even cross or against the grain in that way you get most of the bumps and flats off. 

 Scraping and adjusting the arch :


 The arch is then sanded with a soft bloc and 80 grit in a circular motion starting in the re-curve, you then go through the grits to take the rough sanding marks away.

 The finished result : 


Aucun commentaire:

Enregistrer un commentaire